# Not a fan of LT tanks

**URL:** <https://forum.formlabs.com/t/not-a-fan-of-lt-tanks/19478>\
**Category:** General Discussion\
**Created:** [July 7, 2018, 3:42am UTC](https://forum.formlabs.com/t/not-a-fan-of-lt-tanks/19478 "2018-07-07T03:42:38Z")\
**Posts on this page:** 1\
**Showing post:** 42

<div class="post-metadata">

**Author:** ![alan1950](https://avatars.discourse-cdn.com/v4/letter/a/6de8d8/32.png) [@alan1950](https://forum.formlabs.com/u/alan1950)\
**Post date:** [September 30, 2018, 10:10pm UTC](https://forum.formlabs.com/t/not-a-fan-of-lt-tanks/19478/42 "2018-09-30T22:10:58Z")

</div>

I was having problems with the LT tanks and advised to change the elevation of the print platform as follows:

"on your Form 2, under “Z Fine Tuning.” To bring the build platform down, make sure you hit the minus button, so that the value displayed reads -0.5 mm. Once adjusted, you can try printing as normal. Your Form 2 will remember this setting for subsequent prints. "

It seems to have worked.

---

_[View the full topic](https://forum.formlabs.com/t/not-a-fan-of-lt-tanks/19478)._