# No successfull prints after upgrading to Form 1+

**URL:** https://forum.formlabs.com/t/no-successfull-prints-after-upgrading-to-form-1/3473
**Category:** Support & Troubleshooting
**Created:** [January 30, 2015, 6:22pm UTC](https://forum.formlabs.com/t/no-successfull-prints-after-upgrading-to-form-1/3473 "2015-01-30T18:22:50Z")
**Posts on this page:** 3
**Page:** 1

<div class="post-metadata">

### Author: ![ChrisSteurer](https://avatars.discourse-cdn.com/v4/letter/c/e19adc/32.png) [@ChrisSteurer](https://forum.formlabs.com/u/ChrisSteurer)
#### Post date: [January 30, 2015, 6:22pm UTC](https://forum.formlabs.com/t/no-successfull-prints-after-upgrading-to-form-1/3473/1 "2015-01-30T18:22:50Z")

</div>

Been busy since receiving the upgraded Form 1+, but now that I am using the printer I am unable to get at least one successfull print out of it.  
The resin tank is practical new and the grey resin is stirred, filtered etc. I tried moving the print to another area, but the problem remains.

Some prints were delaminated at the base, so I changed the distance of the built platform.

The first prints came out grainy, with a surface comparable to wood, so I took a look at the large mirror - completely dusty and smeared with something (resin?). I took IPA and flushed the whole mirror without rubbing, which cleaned the mirror.  
Quality of the prints improved, but still…

Prints are often squashed at one end, a lot of prints are chopped off at an 45° angle.

Can someone please help me?

Best regards,  
Chris

Imcomplete prints with grainy surface:  
 ![](http://forum.formlabs.com/uploads/formlabs/2274/076f8837966d5507.JPG)

Delamination:  
 ![](http://forum.formlabs.com/uploads/formlabs/2275/ae8c1319e78b7182.JPG)

Chopped off prints:  
 ![](http://forum.formlabs.com/uploads/formlabs/2276/b0e32a228e86946b.JPG)

---

<div class="post-metadata">

### Author: ![ChrisSteurer](https://avatars.discourse-cdn.com/v4/letter/c/e19adc/32.png) [@ChrisSteurer](https://forum.formlabs.com/u/ChrisSteurer)
#### Post date: [February 1, 2015, 7:36pm UTC](https://forum.formlabs.com/t/no-successfull-prints-after-upgrading-to-form-1/3473/3 "2015-02-01T19:36:27Z")

</div>

I did just submit a ticket with all necessary pictures like advised. Hoping for a simple and cost-efficient solution.

Cheers!

---

<div class="post-metadata">

### Author: ![system](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/3X/5/b/5bc2bdf993ff27c2e0eecab5010b25626fbb327a.png) [@system](https://forum.formlabs.com/u/system)
#### Post date: [February 13, 2015, 6:38pm UTC](https://forum.formlabs.com/t/no-successfull-prints-after-upgrading-to-form-1/3473/4 "2015-02-13T18:38:05Z")

</div>

This topic was automatically closed after 14 days. New replies are no longer allowed.