Larger mini rafts so they don't fall through form cure table?


#1

Mini rafts are awesome - but if they were about twice the diameter then the print legs would not fall through the form cure table holes.


#2

LOL! I noticed that too, even on the standard cleaning station. A civilization of mini-raft legs is slowly growing at the bottom of the alcohol bucket after falling through the holes on the lift tray. But since I regularly run the alcohol through a paint filter for general maintenance cleaning, I figure it’s no big deal.


#3

Great idea. As of PreForm 3.2.0, they are a little bigger and so shouldn’t fall through the holes in the Form Cure.