# Issues with Resin Curing: Need Advice on Best Practices for Quality Prints!

**URL:** <https://forum.formlabs.com/t/issues-with-resin-curing-need-advice-on-best-practices-for-quality-prints/43431>\
**Category:** General Discussion\
**Created:** [January 29, 2025, 9:11am UTC](https://forum.formlabs.com/t/issues-with-resin-curing-need-advice-on-best-practices-for-quality-prints/43431 "2025-01-29T09:11:42Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![danieeljose](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/danieeljose/32/20981_2.png) [@danieeljose](https://forum.formlabs.com/u/danieeljose)\
**Post date:** [January 29, 2025, 9:11am UTC](https://forum.formlabs.com/t/issues-with-resin-curing-need-advice-on-best-practices-for-quality-prints/43431/1 "2025-01-29T09:11:42Z")

</div>

Hi everyone,

I have been using my Formlabs printer for a while now and I have run into a bit of an issue with resin curing. Lately…, some of my prints seem to have uneven curing or the resin appears overexposed, leading to brittle parts or visible lines. I have tried adjusting the exposure settings but I am still facing these problems.

The standard printing settings recommended in the Formlabs documentation. However…, I think the issue might be with my post-processing, specifically the curing stage. Could anyone share tips or best practices for optimal resin curing: ??

Also, is there a certain curing station or setup that works best for this resin type: ?? I want to make sure I am getting the best possible quality for my prints without risking premature failure. I have also gone through this thread [https://forum.formlabs.com/t/prints-cured-on-the-bottom-of-resin-tank-](https://forum.formlabs.com/t/prints-cured-on-the-bottom-of-resin-tank/20249)[qlik-sense](https://www.igmguru.com/data-science-bi/qlik-sense-training) but still looking for some more tips and advice.

Looking forward to your thoughts and suggestions !!

With Regards,  
Daniel Jose

---

<div class="post-metadata">

**Author:** ![system](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/3X/5/b/5bc2bdf993ff27c2e0eecab5010b25626fbb327a.png) [@system](https://forum.formlabs.com/u/system)\
**Post date:** [July 30, 2025, 9:12pm UTC](https://forum.formlabs.com/t/issues-with-resin-curing-need-advice-on-best-practices-for-quality-prints/43431/2 "2025-07-30T21:12:21Z")

</div>

Closed on July 30, 2025, 9:12pm UTC

This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.
