# High temp resin printing problems FORM 2 **URL:** \ **Category:** Support & Troubleshooting\ **Created:** [December 21, 2018, 7:58pm UTC](https://forum.formlabs.com/t/high-temp-resin-printing-problems-form-2/21626 "2018-12-21T19:58:43Z")\ **Posts on this page:** 1\ **Showing post:** 81
**Author:** ![Sculptingman](https://avatars.discourse-cdn.com/v4/letter/s/3be4f8/32.png) [@Sculptingman](https://forum.formlabs.com/u/Sculptingman)\ **Post date:** [January 20, 2019, 12:45am UTC](https://forum.formlabs.com/t/high-temp-resin-printing-problems-form-2/21626/81 "2019-01-20T00:45:55Z")
well that is not good. It should have printed perfectly… and again- the flaw is confined to the interior of the faceted cavity. This is clear evidence that something is awry with your printer- Or it might be positional… that is, you appear to have the narrow hole at the top- closest to the build platform- so the facets are angling out as each layer is added. This might be resin clinging to the underside of these angled facets and getting cured by a laser spot that is not tightly focused due to some issue with optics. If you haven’t opened a ticket with support, Do so and send them this and other pictures of the flaw. I would tend to orient a model like this at a steeper angle… but this is a really strange and persistent flaw. --- _[View the full topic](https://forum.formlabs.com/t/high-temp-resin-printing-problems-form-2/21626)._