# Help

**URL:** <https://forum.formlabs.com/t/help/528>\
**Category:** Support & Troubleshooting\
**Created:** [October 2, 2013, 11:23pm UTC](https://forum.formlabs.com/t/help/528 "2013-10-02T23:23:03Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![itsacyn](https://avatars.discourse-cdn.com/v4/letter/i/eb9ed0/32.png) [@itsacyn](https://forum.formlabs.com/u/itsacyn)\
**Post date:** [October 2, 2013, 11:23pm UTC](https://forum.formlabs.com/t/help/528/1 "2013-10-02T23:23:03Z")

</div>

I have been printing away without a problem and past few weeks nothing prints. I thought perhaps the resin, therefore I cleaned out the resin tank and filled the tank with resin from an open bottle. This didnt help at all. I use the old software, the new software, new stls, saved form files, etc.

Does resin go bad? After each layer the tank does a thud.

I do not know what to do?

---

<div class="post-metadata">

**Author:** ![StevenYarbrough](https://avatars.discourse-cdn.com/v4/letter/s/51bf81/32.png) [@StevenYarbrough](https://forum.formlabs.com/u/StevenYarbrough)\
**Post date:** [October 3, 2013, 7:38pm UTC](https://forum.formlabs.com/t/help/528/2 "2013-10-03T19:38:17Z")

</div>

Check out this post and see if it helps you out. &nbsp;If not, I would submit a support request to Formlabs.

[https://support.formlabs.com/entries/25165088-Clicking-During-Peeling-Repair-Process](https://support.formlabs.com/entries/25165088-Clicking-During-Peeling-Repair-Process)

---

<div class="post-metadata">

**Author:** ![JoryB](https://avatars.discourse-cdn.com/v4/letter/j/59ef9b/32.png) [@JoryB](https://forum.formlabs.com/u/JoryB)\
**Post date:** [October 8, 2013, 8:47pm UTC](https://forum.formlabs.com/t/help/528/3 "2013-10-08T20:47:39Z")

</div>

Hello,

Just wanted to let you know that we will be handling your issues through the support ticket you submitted. I assure you that we will have you printing successfully once again!