# GreyV4 resin printing

**URL:** <https://forum.formlabs.com/t/greyv4-resin-printing/34903>\
**Category:** Form 3L\
**Created:** [October 7, 2022, 6:44am UTC](https://forum.formlabs.com/t/greyv4-resin-printing/34903 "2022-10-07T06:44:03Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Errore](https://avatars.discourse-cdn.com/v4/letter/e/5f9b8f/32.png) [@Errore](https://forum.formlabs.com/u/Errore)\
**Post date:** [October 7, 2022, 6:44am UTC](https://forum.formlabs.com/t/greyv4-resin-printing/34903/1 "2022-10-07T06:44:03Z")

</div>

I have problem issue about printing this sole in attach:

Do you have some advices?

> **[1](https://ibb.co/xMsvyjz)**
>
> Image 1 hosted in ImgBB

> **[2](https://ibb.co/HrDW4ZW)**
>
> Image 2 hosted in ImgBB

> **[3](https://ibb.co/P9KMhm5)**
>
> Image 3 hosted in ImgBB

> **[4](https://ibb.co/QdpyjGv)**
>
> Image 4 hosted in ImgBB

> **[5](https://ibb.co/C2QcMvf)**
>
> Image 5 hosted in ImgBB

> **[6](https://ibb.co/hYydTfd)**
>
> Image 6 hosted in ImgBB

> **[7](https://ibb.co/rx6b1pC)**
>
> Image 7 hosted in ImgBB

---

<div class="post-metadata">

**Author:** ![Errore](https://avatars.discourse-cdn.com/v4/letter/e/5f9b8f/32.png) [@Errore](https://forum.formlabs.com/u/Errore)\
**Post date:** [October 7, 2022, 6:58am UTC](https://forum.formlabs.com/t/greyv4-resin-printing/34903/2 "2022-10-07T06:58:58Z")

</div>

Do you think could be OK in this way?

> **[1](https://ibb.co/FxBcNyB)**
>
> Image 1 hosted in ImgBB

---

<div class="post-metadata">

**Author:** ![Jesse\_K](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/jesse_k/32/18872_2.png) [@Jesse\_K](https://forum.formlabs.com/u/Jesse_K)\
**Post date:** [October 7, 2022, 3:49pm UTC](https://forum.formlabs.com/t/greyv4-resin-printing/34903/3 "2022-10-07T15:49:06Z")

</div>

Hi @Errore,

I do believe angling the part is more likely to yield a successful print, since orienting the part completely vertically can make the part more prone to wobbling during the peel process (see [Model orientation best practices for SLA printing](https://support.formlabs.com/s/article/Model-Orientation?language=en_US) for more info). With that said, I would advise [getting in touch with our Support Team](https://support.formlabs.com/s/contact-support?language=en_US) as the print failure you had could be related to other factors aside from the orientation.