# Form2 thoughts! **URL:** \ **Category:** General Discussion\ **Created:** [September 22, 2015, 2:49pm UTC](https://forum.formlabs.com/t/form2-thoughts/6380 "2015-09-22T14:49:50Z")\ **Posts on this page:** 1\ **Showing post:** 66
**Author:** ![Greg\_Bethel](https://avatars.discourse-cdn.com/v4/letter/g/77aa72/32.png) [@Greg\_Bethel](https://forum.formlabs.com/u/Greg_Bethel)\ **Post date:** [September 23, 2015, 4:06pm UTC](https://forum.formlabs.com/t/form2-thoughts/6380/66 "2015-09-23T16:06:52Z")
> [@David\_Miller](#): > > a thread where someone recommended a chicken coop heater @ChristopherBarr Here’s that heater: > [@DIY print chamber HEATER that works great](http://forum.formlabs.com/t/diy-print-chamber-heater-that-works-great/3769): > > Living in Minnesota, there are many months of the year where my workroom is barely above 60 degrees F in the morning, and doesn’t get above 67 at any point in the day. The print success rate always drops for me when the temps drop, even if I prewarm the resin. After several failures, I finally found a great solution for maintaing a constant temp in the printing chamber, and it’s been working very well for several months now this winter. The product I bought and adapted for my Form1 is a small… --- _[View the full topic](https://forum.formlabs.com/t/form2-thoughts/6380)._