# Form 3 New Firmware 1.8.3

**URL:** <https://forum.formlabs.com/t/form-3-new-firmware-1-8-3/29455>\
**Category:** General Discussion\
**Created:** [November 25, 2020, 11:37pm UTC](https://forum.formlabs.com/t/form-3-new-firmware-1-8-3/29455 "2020-11-25T23:37:58Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![rybu](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/rybu/32/14917_2.png) [@rybu](https://forum.formlabs.com/u/rybu)\
**Post date:** [November 25, 2020, 11:37pm UTC](https://forum.formlabs.com/t/form-3-new-firmware-1-8-3/29455/1 "2020-11-25T23:37:59Z")

</div>

The new firmware states it only supplies “various bug fixes”.

But there appears to be some other changes. There is a “skip” button during the resin heat-up stage in early printing.

I have not noticed anything else new.

---

<div class="post-metadata">

**Author:** ![Randy\_Cohen](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/randy_cohen/32/1500_2.png) [@Randy\_Cohen](https://forum.formlabs.com/u/Randy_Cohen)\
**Post date:** [November 26, 2020, 4:09am UTC](https://forum.formlabs.com/t/form-3-new-firmware-1-8-3/29455/2 "2020-11-26T04:09:40Z")

</div>

You’d think there’d be release notes somewhere…

---

<div class="post-metadata">

**Author:** ![hoolito](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/hoolito/32/16517_2.png) [@hoolito](https://forum.formlabs.com/u/hoolito)\
**Post date:** [November 26, 2020, 10:41am UTC](https://forum.formlabs.com/t/form-3-new-firmware-1-8-3/29455/3 "2020-11-26T10:41:16Z")

</div>

My 2 prints after updating the firmware showed an accurate time remaining widget on the display. Previously I was paying no attention to it since it was shamefully off, but these two times were actually spot on.  
I had updated also to Preform to 3.10.2 and coincidentally those were my very first prints with Tough2000, I don’t know if that contributed too.

---

<div class="post-metadata">

**Author:** ![hoolito](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/hoolito/32/16517_2.png) [@hoolito](https://forum.formlabs.com/u/hoolito)\
**Post date:** [November 27, 2020, 8:38am UTC](https://forum.formlabs.com/t/form-3-new-firmware-1-8-3/29455/4 "2020-11-27T08:38:39Z")

</div>

Oh, forgot to mention that one print was adaptive layer height (14h), and the other 100 micron (16h), both estimate widget were accurate.
