# Form 2 using third party resin

**URL:** <https://forum.formlabs.com/t/form-2-using-third-party-resin/46185>\
**Category:** General Discussion\
**Created:** [March 23, 2026, 9:49pm UTC](https://forum.formlabs.com/t/form-2-using-third-party-resin/46185 "2026-03-23T21:49:00Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![miguelmn3d](https://avatars.discourse-cdn.com/v4/letter/m/7feea3/32.png) [@miguelmn3d](https://forum.formlabs.com/u/miguelmn3d)\
**Post date:** [March 23, 2026, 9:49pm UTC](https://forum.formlabs.com/t/form-2-using-third-party-resin/46185/1 "2026-03-23T21:49:00Z")

</div>

Hello,

Any owners of a Formlabs Form 2 using third party resins?

I have a Form 2 and given that Formlabs is, or has, discontinued selling resin for this printer, I need to start using a third party resin, like Sunlu, AnyCubic, etc. actually I would prefer using third party resin due to the low cost.

I did try AnyCubic initially but ran into problems with it. Recently I tried Sunlu water washable resin but I’ve encountered failures with it as well. At first I used a used, but cleaned, resin tank, and warm up the printer, and resin. Prints failed. I then opened a brand new resin tank but I still got failures. The printer works great when printing with Formlabs resin, which I don’t have much left of.

At this point I’m not sure what to do, other than trash the printer and save for a new Form 4.

Any suggestions?

Thanks!

---

<div class="post-metadata">

**Author:** ![BotzenDesign](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/botzendesign/32/22764_2.png) [@BotzenDesign](https://forum.formlabs.com/u/BotzenDesign)\
**Post date:** [March 24, 2026, 6:24pm UTC](https://forum.formlabs.com/t/form-2-using-third-party-resin/46185/2 "2026-03-24T18:24:52Z")

</div>

I have has success with Creality ABS like on my form 4. You can read about it here. [Open material mode - #18 by leonhart88](https://forum.formlabs.com/t/open-material-mode/43590/18)

---

<div class="post-metadata">

**Author:** ![system](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/3X/5/b/5bc2bdf993ff27c2e0eecab5010b25626fbb327a.png) [@system](https://forum.formlabs.com/u/system)\
**Post date:** [September 23, 2026, 6:25am UTC](https://forum.formlabs.com/t/form-2-using-third-party-resin/46185/3 "2026-09-23T06:25:11Z")

</div>

Closed on September 23, 2026, 6:25am UTC

This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.
