# DIY Form2 UV cure box with turntable for ~ $100

**URL:** <https://forum.formlabs.com/t/diy-form2-uv-cure-box-with-turntable-for-100/13593>\
**Category:** General Discussion\
**Created:** [June 5, 2017, 7:28pm UTC](https://forum.formlabs.com/t/diy-form2-uv-cure-box-with-turntable-for-100/13593 "2017-06-05T19:28:34Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Smisra1968](https://avatars.discourse-cdn.com/v4/letter/s/13edae/32.png) [@Smisra1968](https://forum.formlabs.com/u/Smisra1968)\
**Post date:** [June 5, 2017, 7:28pm UTC](https://forum.formlabs.com/t/diy-form2-uv-cure-box-with-turntable-for-100/13593/1 "2017-06-05T19:28:34Z")

</div>

Before Formlabs released the Curebox, I built this.

- Wood box that I had laying around
- Covered the insides with reflective vinyl
- Attached a nail drying tube UV box on top as a lid
- Cutout a hole on the side and attached a UV LED fixture on the side ([https://www.amazon.com/gp/product/B018C71QHI/ref=oh\_aui\_detailpage\_o07\_s00?ie=UTF8&psc=1](https://www.amazon.com/gp/product/B018C71QHI/ref=oh_aui_detailpage_o07_s00?ie=UTF8&psc=1))
- Used a low rpm gearbox (12V) and printed an enclosure for it ([https://www.amazon.com/gp/product/B01MXPNX7P/ref=oh\_aui\_detailpage\_o01\_s00?ie=UTF8&psc=1](https://www.amazon.com/gp/product/B01MXPNX7P/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1))
- Printed a turntable.

Videos at [https://youtu.be/AfqK-gak4sM](https://youtu.be/AfqK-gak4sM) and [https://youtu.be/snPRUuAVCGY](https://youtu.be/snPRUuAVCGY)