# Current Sensor on Peel Motor

**URL:** <https://forum.formlabs.com/t/current-sensor-on-peel-motor/1961>\
**Category:** Feature Requests & Ideas\
**Created:** [September 13, 2014, 3:54am UTC](https://forum.formlabs.com/t/current-sensor-on-peel-motor/1961 "2014-09-13T03:54:30Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![JoshK](https://avatars.discourse-cdn.com/v4/letter/j/4da419/32.png) [@JoshK](https://forum.formlabs.com/u/JoshK)\
**Post date:** [November 1, 2014, 4:05pm UTC](https://forum.formlabs.com/t/current-sensor-on-peel-motor/1961/3 "2014-11-01T16:05:26Z")

</div>

(This post was moved to it’s own thread)

Everyone says failed prints damage the PDMS, so it must, but when it happens to me I just lift it off and throw it away. My tank is always fine. Under what conditions does the tank get ruined? Does the printer ruin it or the attempt to pull the cured resin off?

---

_[View the full topic](https://forum.formlabs.com/t/current-sensor-on-peel-motor/1961)._