# Castable Wax Schedules

**URL:** <https://forum.formlabs.com/t/castable-wax-schedules/24805>\
**Category:** Feature Requests & Ideas\
**Created:** [September 25, 2019, 4:53pm UTC](https://forum.formlabs.com/t/castable-wax-schedules/24805 "2019-09-25T16:53:41Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![katkramer](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/katkramer/32/15796_2.png) [@katkramer](https://forum.formlabs.com/u/katkramer)\
**Post date:** [September 25, 2019, 4:53pm UTC](https://forum.formlabs.com/t/castable-wax-schedules/24805/1 "2019-09-25T16:53:41Z")

</div>

I’ve been out of the loop for about a year, but just tried to find a Castable Wax schedule that’s easy to understand. As a glass artist, we have a WAY different way of programming our kilns that corresponds with three-button and full-button controllers. I have been sitting here with a _calculator_ actually trying to make sense of the schedules printed in several places on the site, and in particular the short burnout schedule:

> **[\-ENUS-P-Castable-Wax-Jewelry-Pattern-Burnout-Process.pdf](https://media.formlabs.com/m/6b4018a61335afb9/original/-ENUS-P-Castable-Wax-Jewelry-Pattern-Burnout-Process.pdf)**

[https://media.formlabs.com/m/790649687abd37c0/original/-ENUS-P-Introduction-to-Casting-for-3D-Printed-Jewelry-Patterns.pdf](https://media.formlabs.com/m/790649687abd37c0/original/-ENUS-P-Introduction-to-Casting-for-3D-Printed-Jewelry-Patterns.pdf)

 ![image](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/2X/e/e8eef5865dd643298555e489c5d3927e367c1b92.png)

Here is an alternate method of writing out a kiln schedule that requires no calculations, and is easy to program with the kiln:

 ![image](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/2X/e/ec8b49114f26192b92f7f73e713aaf2136f9557d.png)

When you are entering the information into an Orton or Bartlett controller, which are extremely common on widely available kilns, it asks you three items for each cycle: Ramp, Temp, and Hold. The chart I included above shows only the necessary information that needs to be programmed. I’m using a Paragon SC2 and a Paragon XL, but I also own an AIM Kiln and a Jen-Ken that are all programmed in a similar manner.

I can’t imagine how someone without math skills can make sense of the schedules in the handouts…perhaps it’s taught that way in jewelry schools? But for the average person picking up a programmable kiln, this is a far easier way to communicate the information.

I would also suggest that since Formlabs is a US company, that you make sure to include °F in all of your documentation relating to burnout. I found a couple of schedules and graphs that were all in °C. I believe my kiln has a setting where I could switch over, but all of my glass schedules are in °F, so I’d prefer to leave it as °F.

Interestingly, I prefer the metric system for making jewelry, and I know the Imperial units are difficult!

Just a thought.
