# Build Platform fell apart during print **URL:** \ **Category:** Form 2\ **Created:** [March 3, 2018, 10:34am UTC](https://forum.formlabs.com/t/build-platform-fell-apart-during-print/17724 "2018-03-03T10:34:53Z")\ **Posts on this page:** 1\ **Showing post:** 9
**Author:** ![ken](https://avatars.discourse-cdn.com/v4/letter/k/cc9497/32.png) [@ken](https://forum.formlabs.com/u/ken)\ **Post date:** [March 10, 2018, 7:47am UTC](https://forum.formlabs.com/t/build-platform-fell-apart-during-print/17724/9 "2018-03-10T07:47:15Z")
I found this from another thread. > [@Form Wash - no gaskets?!](http://forum.formlabs.com/t/form-wash-no-gaskets/15640/9): > > For reference, the lower fill line will submerge an empty platform by about 2mm and the max fill line will reach about 2/3 up the platform as you’re seeing. Some geometries may displace IPA at the maximum fill line but that’s at the upper limits of part bounding boxes. Submerging the platform shouldn’t case issue and won’t leach byproducts into the IPA. Some older platforms had small openings that would allow IPA to enter them though we took steps to correct this a while back. If your platforms… I’m not sure if I understood the post correctly, but if I did, then it means, newer platforms should not have this issue as the problem was already addressed in the past. A confirmation from formlabs will be really helpful. --- _[View the full topic](https://forum.formlabs.com/t/build-platform-fell-apart-during-print/17724)._