# Bad prints out of brand New Form 3

**URL:** <https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346>\
**Category:** Form 3/3+\
**Created:** [November 11, 2019, 3:28am UTC](https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346 "2019-11-11T03:28:14Z")\
**Posts on this page:** 1\
**Showing post:** 63

<div class="post-metadata">

**Author:** ![rkagerer](https://avatars.discourse-cdn.com/v4/letter/r/439d5e/32.png) [@rkagerer](https://forum.formlabs.com/u/rkagerer)\
**Post date:** [December 14, 2019, 8:49pm UTC](https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346/63 "2019-12-14T20:49:09Z")

</div>

[Tried the cups again](http://forum.formlabs.com/t/form-3-vs-form-2-faceoff/25489/20) on my Form 3 using the 1.4.4 firmware that released Wednesday:

[![](https://i.imgur.com/xVRpTF3.jpg) ](https://i.imgur.com/xVRpTF3.jpg)

Both of these are from the Form 3. The layer shift ripples are still present. Preform was version 3.2.2.

---

_[View the full topic](https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346)._