# Bad prints out of brand New Form 3

**URL:** <https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346>\
**Category:** Form 3/3+\
**Created:** [November 11, 2019, 3:28am UTC](https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346 "2019-11-11T03:28:14Z")\
**Posts on this page:** 1\
**Showing post:** 398

<div class="post-metadata">

**Author:** ![The\_Lab\_Partners](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/the_lab_partners/32/3117_2.png) [@The\_Lab\_Partners](https://forum.formlabs.com/u/The_Lab_Partners)\
**Post date:** [June 25, 2020, 3:20am UTC](https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346/398 "2020-06-25T03:20:44Z")

</div>

Just to collate data for as many resins as possible-- I’ve been trying to address the same issues discussed in this thread (overcuring, layer-shifting, etc.) with Castable Wax resin at 25 microns to no avail.

I would be interested to hear from anyone successfully printing high resolution Castable Wax on the Form 3.

-JD  
[Lab Partners Jewelry](http://labpartnersjewelry.com/)

 ![06-24-2020](https://us1.discourse-cdn.com/flex025/uploads/formlabs/original/3X/e/7/e75571850aa526227b093b6ef324166bbae2c508.jpg)

> [@Printing 25 micron jewelry with Form3](http://forum.formlabs.com/t/printing-25-micron-jewelry-with-form3/27939):
>
> Last month I printed a dozen rings to test the Form3’s new light-touch supports for castable wax resin at 25 microns with Preform 3.5.0 and firmware rc-1.6.7-584 (21 May 2020) First the Good News: 25 micron printing with castable wax resin creates very clean surface detail. As someone who has been running a Form 2 at 25 microns, it’s nice to see the beta settings for jewelry pushed live. The light-touch point supports are significantly smaller than standard supports, and peel off…

---

_[View the full topic](https://forum.formlabs.com/t/bad-prints-out-of-brand-new-form-3/25346)._