# B9 Creator Emerald Resin

**URL:** <https://forum.formlabs.com/t/b9-creator-emerald-resin/13011>\
**Category:** Experimental\
**Created:** [April 27, 2017, 5:19pm UTC](https://forum.formlabs.com/t/b9-creator-emerald-resin/13011 "2017-04-27T17:19:41Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![pr19939](https://avatars.discourse-cdn.com/v4/letter/p/71c47a/32.png) [@pr19939](https://forum.formlabs.com/u/pr19939)\
**Post date:** [April 27, 2017, 5:19pm UTC](https://forum.formlabs.com/t/b9-creator-emerald-resin/13011/1 "2017-04-27T17:19:41Z")

</div>

All,  
I was wondering if anyone had tried the B9 Emerald Resin on Form 2. If yes, I would love to hear the settings and outcome.

Thanks  
Venkatesh S

---

<div class="post-metadata">

**Author:** ![rclaborne](https://sea1.discourse-cdn.com/flex025/user_avatar/forum.formlabs.com/rclaborne/32/8369_2.png) [@rclaborne](https://forum.formlabs.com/u/rclaborne)\
**Post date:** [April 28, 2017, 5:35pm UTC](https://forum.formlabs.com/t/b9-creator-emerald-resin/13011/2 "2017-04-28T17:35:59Z")

</div>

Ask your question on this topic:

> [@Form 1 / 1+ / 2 3rd Party Resin Settings Master List](http://forum.formlabs.com/t/form-1-1-2-3rd-party-resin-settings-master-list/11312):
>
> Hello, I am currently doing some open mode testing with different 3rd party resins, namely: Photocentric3D Firm Grey Photocentric3D Hard Beige FunToDo F1+ Grey FunToDo SW Snow White (also have two dyes, yellow and black) Autodesk Prototyping Resin Yellow (PR57-Y) Nextdent Tray Blue Bucktown Polymers Clear ZVE500-V420 I am slowly starting to generate a spreadsheet with different settings tried for each resin, and what the results were. Does it make sense to start a type of “Master List” so F…

---

<div class="post-metadata">

**Author:** ![hx19035](https://avatars.discourse-cdn.com/v4/letter/h/f0a364/32.png) [@hx19035](https://forum.formlabs.com/u/hx19035)\
**Post date:** [May 2, 2017, 9:08pm UTC](https://forum.formlabs.com/t/b9-creator-emerald-resin/13011/3 "2017-05-02T21:08:47Z")

</div>

I use that stuff everyday in my little Solus unit. Super high resolution and casts nicely. If any of the Form units can handle a resin of that resolution / viscosity then make sure to turn up the brightness. Stuff needs some sunlight to make the magic happen!!