About the Form 3 category


#1

Post your questions, concerns, comments, and tips related to the Form 3 printer here!


#2

Hi’
Just got my Form 3 a couple of weeks ago, did a couple of prints and they turned out very good. No complaints so far, except for the print time. Takes quite long…
But today, I started a new print, and I see that the Z-axis rode is wobbling quite a bit at the upper end. Not sure it’s normal. Didn’t remark it before, to be honest. Is it possible that it came loose somehow?
Have to wait and see how the print comes out though. Any thoughts?
Thanks in advance!


#3

Does anyone know what went wrong with casting these castable wax V1 printed baseball bats on my form3? I used prestige optima investment and the bats turned out awful, but the hand carved wax rings turned out perfectly! I followed the burnout guidance on formlabs for prestige optima. image|640x480


#4