Support & Troubleshooting   Form 1/1+


About the Form 1/1+ category (1)
I have a critical issue with Form+1 printer (20)
Used Form 1+, Buzzing on start and always "busy" (5)
X Y calibration, tried heaps, out of options (2)
Form 1/+ peel motor 35BYZ-B01-12 Europe group deal (2)
Print being shifted on the x-axis during print (9)
Form 1+ heeeellppppp!!! (2)
Looking for broken Form 1+ (2)
Made some 32mm bases, the side with detail and texture is near perfect, the flat side is warped and wavy (4)
Form 1+ doesn't boot (3)
Clean Lubricate Z-Axis and Rail (7)
PreForm freezing when fine tuning (9)
Tuning for Quality in OpenFL Material Configuration Files ( 2 ) (27)
Prints problem (2)
What do I do when the platform sticks to the tank? (8)
Widen support base (trouble with WaxCast staying on build plate) (3)
What version of Preform is best for Form1+ (17)
Second hand Form1+, not possible to upgrade firmware or fine tune (10)
Fixing the stepper motor (10)
Base Label on Form 1+ (3)
Form 1+ Peel Motor : Refurbished unit had dirty stepper (2)
This was my stepper motor problem (Ball bearing inside) pic (2)
Base will stick to the plate, the rest wont? (11)
Frame that holds the resin tank is shifting forward and backward (6)
I am very sad with the company Form labs ( 2 ) (39)
Calibrating the laser? ( 2 ) (29)
Print failed, black resin v2 just arrived from the formlabs (4)
Form 1+ laser spot flare issue and a possible solution (9)
Impossible to print a cylinder (6)
Every print fails - Black Resin (8)