Support & Troubleshooting   Form 3


About the Form 3 category (4)
Grey v4 printing distorted prints (2)
Firmware update LCD scare (6)
Is there a way to re-start (where it was) a print that was interrupted by a power outage? (4)
Dashboard says Form3 is printing, Form3 shows a "Let's set up your printer the first time" kind of display (1)
Pouring resin out to extend tank lifetime? ( 2 3 ) (45)
Form 3 Loud Clicking sounds (14)
Mixer arm not moving while printing (3)
Form3 "Tank Missing" message (11)
Form 3 Mixer Arm not moving, LPU grinding sounds (7)
Loud clicking sound and check mixer error (17)
New Castable Wax 40 (1)
Can't connect over WiFi or Ethernet (5)
Crackeling noisesform 3 (10)
Wavy print lines in clear (8)
Error code 148? (1)
Squeaking noise near the end of LPU transit (7)
New to the Form 3B - does the platform raise while printing? (6)
A bit of resin stick on my Form3's LCD ! Can I wash it with IPA? (1)
Form 3 raft over-adhesion to build platform problem (12)
Form 3 stuck on 'Filling' before print (12)
Many small parts don't don't stick to build plate, or rip off from supports (4)
Resin advice for electronic enclosure install in Distribution Board a bit high temperature (7)
Resin For Worm Gear Assembly (6)
Form3 won't heat up to 31 deg C (12)
Manually enable heater (12)
Touchscreen issue (2)
Elastic resin grossly oversized (7)
Draft V2 Support Tip Shape (5)
PREHEAT work-around! (3)