Open mode reduces the number of things that could go wrong

[JohnHue]

@Dudemeister

I can’t find anything else on this mod, or any posts from other users attempting the mod.

I’ve stumbled upon these two:

Heating the insides of my form 1+

I’m based in the north of Scotland. In the winter my place doesn’t half get cold (think farmhouse cottage in the middle of nowhere) and so I pretty much have to have the heating on even during the day to keep the temperature within the suitable range. I remembered there was a thread fairly recently where someone was using an egg incubator heater to keep the internals of their printer nice and warm. I liked the solution but not the price as the shipping to the UK cost as much as the unit. I a…

DIY print chamber HEATER that works great

Living in Minnesota, there are many months of the year where my workroom is barely above 60 degrees F in the morning, and doesn’t get above 67 at any point in the day. The print success rate always drops for me when the temps drop, even if I prewarm the resin. After several failures, I finally found a great solution for maintaing a constant temp in the printing chamber, and it’s been working very well for several months now this winter. The product I bought and adapted for my Form1 is a small…

And if you google it, there seems to be a few reports of people doing it for a Moai printer.